This Dairy Pasteuriser Operator job description sets out the main duties, qualifications, skills and measures of success for the role, which is also known as HTST Operator, Pasteurizer Operator, Heat Treatment Operator or Liquid Milk Process Operator. Download it free as a Word or PDF template and adapt it for your own vacancy.
This template is a guide only. Adapt it to your vacancy and check it meets the employment law where the job is based before you use it. See our terms of use.
| Job title | Dairy Pasteuriser Operator |
| Also known as | HTST Operator, Pasteurizer Operator, Heat Treatment Operator, Liquid Milk Process Operator |
| Department | Dairy processing (liquid milk and cream) |
| Reports to | Production Shift Supervisor |
| Direct reports | None |
What does a Dairy Pasteuriser Operator do?
Runs the HTST (high temperature short time) pasteuriser and the separator, standardiser and homogeniser that sit with it. Makes sure every litre of milk or cream is heat-treated correctly, standardised to specification and recorded, and that the plant is cleaned between runs.
Dairy Pasteuriser Operator duties and responsibilities
Running the pasteuriser
- Start up, run and shut down the HTST plant to the SOP: balance tank, feed pump, plate heat exchanger, holding tube and flow diversion valve (FDV)
- Sterilise the plant with hot water before product and confirm the set temperature and time were reached
- Check at start-up that the FDV sends milk below the set point back to the balance tank
- Check the booster pump keeps pasteurised milk at higher pressure than raw milk in the regeneration section
- Hold the temperature at or above the minimum, and the flow at or below the rated maximum, so the milk gets the time at temperature required where the job is based; for cows' milk this is commonly 71.7 °C for 15 seconds, or an equivalent combination
- Watch the control screen and act on alarms straight away
- Run changeovers and water pushes so milk is not lost to drain and water stays out of product
Checks and records
- Watch the chart recorder or data logger and confirm temperature and hold time never drop below the limit
- Check the indicating and recording thermometers against a calibrated thermometer at the set frequency and record the result
- Take the alkaline phosphatase sample at the set frequency and, where the site requires it, hold product until the result confirms pasteurisation was effective
- Record start-up checks, temperatures, flows, batch codes and traceability details in the process log as they happen
- Hold any milk that went forward below the time or temperature limit, never release it as pasteurised, and tell the Production Shift Supervisor and quality straight away
Separation, standardisation and homogenisation
- Run the separator and check fat in skim milk to confirm it is separating properly
- Set the standardiser to the target fat for each product and confirm it with a fat test
- Run the homogeniser at the set pressure and temperature so fat globules are broken down
- Send cream to the cream tanks at the right fat and temperature for the next process
Cleaning, food safety and teamwork
- Run the CIP after production and check the caustic and acid cycles reached their set times, temperatures and concentrations before signing the plant off
- Check the final rinse so no chemical is left in the plant
- Follow hand washing, clothing and hygiene zone rules, and keep the hall free of spills
- Lock out before opening the plate pack, homogeniser or any pump, and wear the PPE set for the task
- Report faults, leaks and worn gaskets to maintenance
- Give and receive a clear handover at each shift change
Dairy Pasteuriser Operator qualifications and experience
Essential
- Experience operating process plant in a dairy or food factory
- Ability to follow written procedures exactly
- Ability to read control screens and recorders and act on alarms
- Basic understanding of temperature, flow and pressure
- Good number skills
- Willingness to work rotating shifts, including nights and weekends
Desirable
- Experience on HTST plants, separators or homogenisers
- Basic food hygiene certificate or similar
- HACCP awareness
- Understanding of milk composition (fat, protein, total solids)
- CIP experience
Skills and attributes
- Attention to detail
- Discipline with records
- Calm under pressure
- Clear communication at handover
- Practical problem solving
How success is measured
- No product released below the legal time and temperature
- Phosphatase results pass
- Fat standardisation within specification
- Losses within target
- CIP verified
- Process records complete
- No accidents or injuries
Working conditions and safety
Shift work including nights, weekends and early starts, in a wet, warm and noisy processing hall with hot surfaces, steam and CIP chemicals. Standing for long periods; PPE and training are provided.
- Follow health and safety rules and safe systems of work, and wear the correct PPE
- Follow food safety, hygiene, HACCP and quality procedures at all times
- Report hazards, accidents, near misses and concerns promptly
Dairy Pasteuriser Operator interview questions
Use these questions to assess candidates for a Dairy Pasteuriser Operator role. Each one includes what a good answer shows.
- Why do the holding tube and flow diversion valve matter?
What a good answer shows: Knows the holding tube gives all the milk the full time at temperature, and that the FDV sends milk below the set point back to the balance tank, so under-heated milk never goes forward. - What does the pressure differential in the regeneration section protect against?
What a good answer shows: Knows raw and pasteurised milk are separated only by thin plates, so the booster pump keeps the pasteurised side at higher pressure; if a plate cracks, pasteurised milk leaks into raw, not the other way. - The recorder shows a dip below the minimum temperature. What do you do?
What a good answer shows: Treats it as a failure however short the dip. Confirms that milk was diverted or, if in any doubt, holds it. Releases nothing, tells the Production Shift Supervisor and quality, and keeps the record with a note of what was done. - What does the alkaline phosphatase test tell you?
What a good answer shows: Knows phosphatase is an enzyme in raw milk that correct pasteurisation destroys, so a positive result means under-heated milk or raw milk mixed in. Holds product until the result is in; a fail is a fail, with no re-test. - How do you standardise milk to a fat target?
What a good answer shows: Sets the standardiser or calculates the cream to blend back into skim, confirms with a fat test, and knows fat in the skim shows how well the separator works. A result outside specification is a failure, however close. - Describe your start-up sequence on an HTST plant.
What a good answer shows: Circulates water, sterilises with hot water to the set temperature and time, checks the FDV diverts below the set point, checks the pressure differential, then introduces milk and pushes the water out. - How do you check the thermometers, and how often?
What a good answer shows: Checks the indicating and recording thermometers against a calibrated reference thermometer at the set frequency, records the result, and reports any difference outside tolerance instead of running on an instrument that may read high. - The CIP ran short on the caustic cycle. What do you do?
What a good answer shows: Does not sign the plant off as clean. Reports it, cleans again in full before any product goes through, checks time, temperature and concentration on the repeat, and records what happened. - How do you keep losses low at product changeover?
What a good answer shows: Times the water push so product does not go to drain early and water does not reach the product tank, watches the interface by sight or conductivity, and records losses. - What goes into your handover, and when do you lock out the plant?
What a good answer shows: Covers plant status, the running batch, open faults and checks due, in person and in writing. Locks out and tags before opening the plate pack, homogeniser or a pump, every time.
Hiring a Dairy Pasteuriser Operator? Advertise your vacancy on Dairy Jobs and reach a growing network of approximately 300,000 dairy specialists worldwide, or ask our team about recruitment support. Looking for a Dairy Pasteuriser Operator job? Browse live dairy jobs or create a free job alert. New to the role? Read our guide: How to Become a Dairy Process Operator.
Watch and learn
See an HTST pasteuriser in action, from balance tank to flow diversion valve, in these training animations from the Watson Dairy Consulting YouTube channel.
Related dairy job descriptions
- Dairy Process Operator
- Dairy Production Supervisor
- Dairy CIP Operator
- Dairy Technologist
- Dairy Quality Control Technician
- All dairy job descriptions
Frequently asked questions
Runs the HTST (high temperature short time) pasteuriser and the separator, standardiser and homogeniser that sit with it. Makes sure every litre of milk or cream is heat-treated correctly, standardised to specification and recorded, and that the plant is cleaned between runs.
Employers usually look for: experience operating process plant in a dairy or food factory; the ability to follow written procedures exactly; the ability to read control screens and recorders and act on alarms.
A Dairy Pasteuriser Operator usually reports to the Production Shift Supervisor.
Yes. Download the free Word template, add your location, contract and salary details, and adapt the duties to your site. You can then advertise the role on Dairy Jobs.
© 2026 Dairy Jobs (Specialist Recruiters Ltd). You may adapt this job description for your own vacancies. Please do not republish it.
